Some may not realize it, but there is more than one way available for your carpet cleaner to clean your carpets. It has a “wet cleaning” method or a “dry cleaning” method. Many people would like to know the difference between the two.
While the main difference is that obviously, one involves more water than the other, there is a bit more involved than that. (It should be noted that before starting any of the methods, you must first vacuum the carpet. This makes the cleaning process easier.
Wet cleaning the first method we will look at is the wet method. Wet cleaning methods, as the name suggests, use the most water in the cleaning process. There are two main types: shampooing and steam cleaning.
With the shampoo method, you shampoo the carpet. The cleaning machine covers the fibers with shampoo foam. This process removes dirt and stains. When dirt is removed, it gets trapped inside the shampoo. Once the carpet has dried, it can be vacuumed to clean it. Dirt and stains, which had previously adhered to the carpet fibers, are cleaned with the dry shampoo solution.
Steam cleaning can also be classified as a wet cleaning method. With steam cleaning, your cleaner sprays a mixture of hot water and detergent on the carpet. This loosens the dirt. Then a specialized vacuum cleaner is introduced to suck the water out of the carpet.
Dry cleaning with the dry cleaning method, a wet powder is spread on the carpet and then massaged into the fibers with a special machine. The powder consists mainly of detergent, a dissolving solvent, and an absorbent. It also contains a small amount of water, enough to moisten it. The special composition of the powder allows it to act as a powerful cleaning agent. After the dust is spread over the carpet, it is vacuumed clean.
The advantages and disadvantages of each dry cleaning are considered wet carpet drying melbourne. In other words, it doesn’t clean as deeply as a wet cleaning does. The advantage of this method is that it is faster. With wet cleaning, you may need to wait 12-24 hours for the solution to dry.
And that’s also the potential downside: it takes a bit more time. The advantage, as mentioned, is that it is more forceful and more comprehensive, so the wait is often worth it.
Typical Cleaning Process Most professional cleaners would use something similar to the following process outlined below. First, they inspect the area to be cleaned to understand the layout of the area and the type of dirt and stains it will deal with.
They then vacuum the area to remove as much “easy” dirt as possible. After vacuuming, they pre-condition the carpet with a specialized cleaning solution. This emulsifies dirt and suspended biomaterials. Next, they shake up the areas that get the most foot traffic. This serves to loosen compacted dirt.
After shaking, they rinse off the cleaning solutions applied in Step 3. This leaves the carpet fibers without residue. If there are stubborn stains, then treat these areas with specialized stain removers. If necessary, these areas are allowed to “sit” for a while so the stain removers can do their job. When the proper time has passed, the removal solutions are rinsed off the carpet.
Carpet cleaning: wet or dry?
There are a few carpet cleaning methods that are used professionally. A full vacuum application should be done before using any of these methods, making the general cleaning exercise easier.
Carpet Washing – Wet Cleaning
A professional wet carpet cleaning machine (either cylindrical foam or rotary shampoo) creates a lot of foam on the carpet, removing dirt and stains from the foam. It is then allowed to dry, perhaps overnight, after which it is removed with a vacuum cleaner.
Carpet absorbents – Dry cleaning
A dry powder is spread on the carpet and then machine-spread to penetrate. This powder contains detergent, solvent, absorbent, and very little water. In very dirty areas it is spread using a spray, which is then rubbed off. Finally, a full and deep suction is applied.
Not only is this method the most recommended by manufacturers, but it is also the only one that lives up to the description of “deep cleaning”, as it is capable of removing dirt embedded deep in the carpet. A fine spray of hot water mixed with detergent is applied to the carpet and the carpet moves and mixes in the dirt with the solution, however deep it may be.
A very powerful vacuum cleaner extracts the hot water and stores it in a tank. A portable system can be brought into the home, or a truck-mounted system is used, with extra-long hoses that allow extraction to hold tanks on the truck.
Manufacturers recommend the steam cleaning option, but as long as it is done by a professional, not necessarily for you to do it yourself. Furthermore, this is a practical solution for offices and commercial companies. For residential needs, where traffic and therefore potential dirt is much less, it is not necessarily the best option once costs are taken into account.
When it comes to shampooing carpets and the dry cleaning method, both methods are surface cleaners, not “deep cleaning” methods. This means that some of the dirt and detergent will remain.
Imagine that you are washing your hair. You finished applying the shampoo and then proceed to rinse it off. On a carpet, there will always be some of the shampoos. And the problem with this is that if it is not completely dried and the water removed, the wet thread will always attract and capture more dirt. Therefore, after wet cleaning, circles with slight rings of dirt appear a few days later. With dry cleaning, this will not happen if the instructions are followed correctly.